DESCRIPTION

Cleaning fluid for removing mold and bacteria (e.g. legionellae) from A/C systems in passenger cars, commercial vehicles, buses and in the home without the need for dismantling. After cleaning, this product leaves behind a pleasant fresh fragrance.

PROPERTIES

- expert's microbiological report available
- removes musty smells
- assures fresh, clean air
- increases ride comfort
- forms a protective film
- destroys molds and bacteria
- cleans air inlet ducts

APPLICATION

The cleaning fluid (1 liter) must be mixed with the relevant activation concentrate (2x fragrance in the sealed edge bag) before the A/C system cleaner is used. To do so, pour the activation concentrate into the A/C system cleaning gun and fill with 1 l of A/C system cleaner. Shake gently. The A/C system cleaner is now ready for use. 1 l is sufficient for cleaning one car air conditioning system. If the manufacturer of the air conditioning system offers a cleaning service recommendation, this recommendation must be observed. If no model-specific instructions are available from the passenger car manufacturer, follow the LIQUI MOLY recommendation for application. Spray the cleaning fluid directly on the surface of the evaporator (if possible) for commercial vehicle, bus and home A/C systems.

LIQUI MOLY recommended use:

• During the cleaning process, make sure the window is open and avoid inhaling the vapors.

• Check to make sure that the condensation water drainage is not blocked.

• Dry the surface of the evaporator for 10 minutes with the engine running using the following heater and blower settings: Switch off the air conditioning and set to air circulation mode. Set the air distribution switch to footwell.

• Turn the temperature regulator and blower selector to maximum Cleaning the air conditioning system: Insert the cleaner probe toward the evaporator (center of the vehicle).

• See vehicle-specific instructions at www.liqui-moly.de.

• Actuate the cleaner and move the spray probe carefully back and forth to flush out and clean the evaporator thoroughly with LIQUI MOLY Air Conditioning Cleaner.

• Allow 15 - 20 minutes for the cleaner to take effect.

• Dry the surface of the evaporator for 10 minutes with the heater and blower at the same setting as prior to cleaning. Replace and insert dust and pollen filter.

• Please note: Any cleaner which is spilled must be wiped up using a damp cloth and water.